CAMLOG SCREW-LINE Surgical procedure

10 CAMLOG ® SCREW-LINE IMPLANT Ø 2.5 mm external diameter 10 mm 4 mm Example: CT-tubes for CT-planning for pilot drill Ø 2.0 mm Drill for placement of CT-tubes Ø 2.1 mm internal diameter X-RAY/DRILLING TEMPLATE WITH CT-TUBES FOR CT-PLANNING CT-tubes for the CT-planning are integrated at the appropriate implant po- sitions in the planning templates created from the wax-up/set-up and are used as reference positions in the X-ray image. The CT-tubes have two parts and are made of titanium because this material does not cause any scatte- ring of rays in the CT/DVT. The lower section is polymerized into the temp- late. The upper section is pluggable. The entire CT-tube is used for the ra- diological diagnostics; the upper section can be removed for surgery. Depending on the software used for the evaluation, titanium CT-tubes or other radio-opaque positioning elements (e.g. steel, barium sulfate) are in- tegrated for the CT/DVT-supported planning. Placing the CT-tubes directly on the mucosa makes it possible to determine its density in the CT/DVT. The documentation included with these systems contains more information on this topic. ORTHOPANTOMOGRAPH X-Ray planning foils are available in 1.25:1 and 1.4:1 scales for all implant types to check the dimensions on the orthopantomograph. The foil magni- fications match the delay factors for most orthopantomographs. However, they should be considered only as approximations in implant dimensioning. The self-adhesive implant planning films (X-Ray Transfer pictures, scale 1.25:1) for the specific implant type can be attached to the proposed im- plant positions on the orthopantomograph film. +E219K530090101K +$0010017460KX K5300.9010 Rev. 2 03/2017 71299Wimsheim Germany 4053 Basel, Switzerland r. 5 r. 38 219K530 90101K 0020 17460KY IMPLANT POSITION PLANNING