CAMLOG SCREW-LINE Surgical procedure

20 CAMLOG ® SCREW-LINE IMPLANT PILOT DRILLING AND DEPTH CONTROL The pilot drill determines the depth and axis of the implant site. The depth marks on the drill correspond to the implant lengths 7 * , 9, 11 and 13 mm. The maximum drilling depth is 16 mm. For safety reasons, a depth stop mat- ching the proposed implant length should be used. Recommended drilling speed: 800 rpm If no drilling template is used, the depth stops may be placed to the pilot drill after the markings have been drilled. Once drilling is complete, the depth and axis of the implant bed is checked using the paralleling pins. If several implants are being placed, a paralleling pin is inserted into the first hole in order to align the other implant axes. The pilot drill is aligned parallel to the paralleling pin and visually checked from two planes (sagittal and transversal). Pilot drill, Ø 2.0 mm 800 rpm Pilot drilling Depth control following pilot drilling Paralleling pin SCREW-LINE 16 mm 13 mm 11 mm 9 mm 7 mm* 0 SURGICAL PROCEDURE * The lowest marking corresponds to a drilling depth of 7 mm and is of no significance for the CAMLOG ® SCREW-LINE implants.