CAMLOG Vario SR Prosthetics Components

CAMLOG ® VARIO SR PROSTHETIC COMPONENTS ABUTMENT INSERTION Clean the internal configuration of the implant before inserting the abut- ment. The selected CAMLOG ® Vario SR abutment is inserted in the CAMLOG ® implant and rotated until tactile engagement of the cams in the grooves of the implant. The abutment is then in the final position. A screwdriver (hex) and torque wrench are used to tighten the abutment screw with a torque of 20 Ncm. To achieve maximum pre-tension on the screws, the abutment screw should be retightened with the same torque after approx. 5 minutes. IMPORTANT NOTE The special design of the CAMLOG ® Vario SR abutment screw and the CAMLOG ® Vario SR lab screw for the straight CAMLOG ® Vario SR abutment requires the sole use of the screwdriver, hex, Art. No. J5316.0501/0502/0503/0504/0510! We recommend taking a control x-ray to make sure the abutment is cor- rectly seated on the implant. IMPORTANT NOTE CAMLOG ® Vario SR abutments may not be modified. This would com- promise the matched shape of the Vario SR prosthetic components. ATTENTION! MAKE SURE THAT THE ABUTMENT SCREW TYPES MATCH! • Straight CAMLOG ® Vario SR abutments = use CAMLOG ® Vario SR abutment screws • Angled CAMLOG ® Vario SR abutments (20°/30°) = use CAMLOG ® abutment screws Screwdriver (hex) and torque wrench with continuous torque adjustment Screwdriver, hex, extra short, short, long 20 Ncm