Work Instruction COMFOUR®

15 OCCLUSALLY SCREW-RETAINED PROSTHETICS ON CAMLOG ® AND CONELOG ® BAR ABUTMENTS SCREW, HEX, FOR BAR ABUTMENT, for open tray impression taking and soldering, can be shortened extraorally by 2.5 mm, titanium alloy (Ti6Al4V ELI), sterile Length 10 mm 15 mm 20 mm Thread M1.6/M2.0 M1.6/M2.0 M1.6/M2.0 ART. NO. J4012.1610/2010 J4012.1615/2015 J4012.1620/2020 TITANIUM CAPS FOR BAR ABUTMENTS FOR IMPRESSION TAKING WITH OPEN TRAY The titanium caps for bar abutments are available with and without antiro- tational mechanism and can be used for direct impression taking on the bar abutments. They are made of titanium alloy (Ti6Al4V ELI), can be short- ened individually and are available packed sterile with a light blue an­ odized prosthetic screw. Sterile, light blue anodized screws, hex, in various lengths are available for fixation of the caps for impression taking directly on the bar abutments. See also information on screw thread sizes M1.6 and M2.0 on page 9. The caps can be shortened occlusally by 8.5 mm up to and including the fourth chamfer. The impression caps are again connected to the driver for impression caps and unscrewed from the bar abutment. The bar abutments remain in the implants. The impression caps are handed over to the dental laboratory. ART. NO. J2259.4301 J2259.6001 J2259.4302 J2259.6002 Implant-Ø 3.3/3.8/4.3 mm 5.0 mm 3.3/3.8/4.3 mm 5.0 mm Titanium cap for bar abutment, for crown, with antirotational mecha- nism, incl. prosthetic screw, sterile Can be shortened by 8.5 mm Height 14.0 mm Titanium cap for bar abutment, for bridge, incl. prosthetic screw, sterile