Titanium Bases CAD/CAM Crown and Bridge Restorations

10 TITANIUM BASES CAD/CAM FOR CROWN AND BRIDGE RESTORATIONS CAMLOG ® SCANBODY, CONELOG ® SCANBODY, incl. abutment screw, sterile incl. abutment screw, sterile ART. NO. K2610.3310 K2610.3810 K2610.4310 K2610.6010 C2600.3310 C2600.4310 C2600.5010 Implant Ø in mm 3.3 3.8 4.3 5.0/6.0 3.3 3.8/4.3 5.0 Prosthetic height in mm 10.0 10.0 10.0 10.0 10.0 10.0 10.0 RECORDING OF THE IMPLANT/LAB ANALOG POSITION BY SCANNING The CAMLOG ® and CONELOG ® Scanbodies are used for optical three-­ dimensional localization (incl. determination of the axial inclination and orientation of the grooves) of CAMLOG ® and CONELOG ® Implants in the mouth and of CAMLOG ® and CONELOG ® Lab analogs in the working model. The scanbodies are available for all implant diameters, labeled according to the corresponding implant diameter and are delivered sterile, each with an abutment screw. To prevent a vertical offset by the conical CONELOG ® Implant-abutment connection, the CONELOG ® Scanbody is flush with the shoulder of the CONELOG ® Implant/Lab analog after screwing. NOTE The single use of the sterile scanbody is limited to use in the mouth. The scanbody can be used repeatedly on the working model taking the integrity of the scanbodies into account. DIRECT SCANNING OF THE TITANIUM BASE CAD/CAM ON THE CAST After fabricating the cast, the CAMLOG ® or CONELOG ® Titanium base CAD/ CAM, crown or bridge, is placed in a corresponding lab analog and fixed hand-tight with the corresponding bonding aid. The titanium base must be seated in the lab analog correctly. Optionally, the titanium base can also be fixed hand-tight in the lab analog with the corresponding lab screw using a screwdriver, hex. If the titanium base was fixed with a lab screw, the screw channel must be sealed with a removable material before scanning.