CAMLOG Vario SR Prosthetics Components

CAMLOG ® VARIO SR PROSTHETIC COMPONENTS STANDARDIZED CAST FABRICATION Impression-taking and fabrication of the cast for bridge and bar construc- tions take place by using prefabricated Vario SR components, and for single crowns, with components of the CAMLOG ® Implant System. The fixing screws of the Vario SR impression caps, open tray, respectively the CAMLOG ® impression posts, open and closed tray, are hand-tightened us- ing a screwdriver (hex) with the Vario SR analogs or CAMLOG ® lab analogs for cast fabrication. NOTE The components must not be modified! CAST FABRICATION WITH VARIO SR IMPRESSION CAP, OPEN TRAY After the impression is taken, the Vario SR impression caps, open tray, are in the impression. The Vario SR analogs corresponding to the diameters are attached to the Vario SR impression caps, closed tray, in the impression (note proper seat- ing) in the dental laboratory. A screwdriver (hex) is used to hand-tighten the fixing screw. Vario SR impression cap, open tray, with Vario SR analog NOTE Vario SR impression caps, open and closed tray, have no antirotational mechanism and therefore are only suited for impressions directly over CAMLOG ® Vario SR abutments for bridge and bar constructions. There- fore, the cast is only fabricated with Vario SR analogs. CAST FABRICATION FOR BRIDGE AND BAR RESTORATIONS WITH VARIO SR ANALOGS If the impression was taken over the already inserted CAMLOG ® Vario SR abutment (straight and/or angled), the Vario SR analog is used. The Vario SR analog is hand-tightened onto the respective Vario SR impression cap, open or closed tray, used. CAST FABRICATION ART. NO. ARTICLE FOR IMPLANT DIAMETERS J2567.4300 Vario SR analog 3.8/4.3 mm J2567.6000 Vario SR analog 5.0/6.0 mm